News

Pressure spray dryer machine works: In high pressure liquid feed (filtered liquid material) into the pressure atomizer atomized into small droplets, through droplets atomized (greatly increased surface area) full contact with the hot air, the rapid completion of the drying process , then get the finished powder or fine particles. Features: Pressure spray dryer has the following characteristics: A fast drying, greatly increasing the surface area of the material after the liquid is atomized, in a hot air stream, the moment 95-98% of water can be evaporated, to complete the drying time is only ten seconds to tens of seconds, especially for drying heat-sensitive materials. Second, the resulting product is spherical particles, uniform size, mobility, solubility, high purity and good quality. Third, using a wide range, depending on the characteristics of materials, can also be used with hot air drying granulator cold, strong adaptability of the materials. Fourth, simple operation and stable, easy to control, easy to automate operations.

Pressure Pressure atomizer spray drying can be done at the same time a granulator and granulating drying apparatus, the material can be adjusted according to process requirements of the pressure pump, the size of the flow orifice of the desired size by a certain proportion of spherical particles. It uses pressure diaphragm pump with the help of the atomized solution or slurry material into small droplets, and then fall with a hot air flow, most particles collected from the bottom discharge opening, gas and tiny powder through cyclone separation, the significant increase in surface area, by heat exchange with the hot air sufficiently to rapid drying (over 10 seconds to tens of seconds), or fine particles obtained product equipment. Its source device using steam heating or electric heaters, with easy operation, start fast, compact, hot air are clean and so on. Also in the electrical control cabinet is equipped with an electric heater control adjustment means, the inlet temperature is not adjustable. For lack of electricity can be steam heating or coal, fue stove, etc., partially or completely replace the electric heating devices.

What is the Air Stream Crash Dryer? It means by heating the material in the moisture (usually water or other volatile liquid component) vaporization escape, in order to obtain a predetermined moisture content of solid materials machinery and equipment. Large amount of energy required in the process of drying, and in order to save energy, certain high moisture content of the material, containing suspended solids or solution is generally first by mechanical dewatering or heating evaporation, and then dried in air dryer to obtain dry solids. The dried material is designed to use or further processing needs. Such as the production of wood drying wood molding, wood products can prevent the deformation front, ceramic blanks in the dry before calcination finished cracking can be prevented. In addition the material after drying is also easy to transport and storage, as the harvested grain is dried to a certain moisture content or less, to prevent mildew.

This month our company will attend the China CPHI exhibition in Shanghai in 24th, welcome to visit our booth.